Code Alarm Automobile Alarm HQ 2610 User Manual

Model CATX110  
Programming Guide  
The keychain transmitters included with the system have  
been pre-programmed at the factory, with each button pre-  
assigned to control a specific function of the system.  
It is important to remember that during programming, each  
individual step of the procedure must be executed within 15  
seconds of the previous step.  
When the 15 second time limit is allowed to expire, the  
system will automatically terminate the programming mode.  
This is indicated by a long chirp from the siren.  
Additionally, the system will store codes from up to 4  
different transmitters. If a 5th transmitter is programmed to  
any receiver channel, then the first transmitter programmed  
to that channel will be erased from the system’s memory.  
To program new or additional transmitters, the alarm must  
be disarmed and the valet switch must be in the OFF  
position:  
1. Enter the vehicle, and turn the ignition key to the ON  
position.  
2. Flip the valet switch ON then OFF 3 times  
3. The dash LED will flash one time, and the sounding  
device will beep one time, indication the system is ready to  
accept programming for receiver channel 1.  
4. Press and hold the Arm/Disarm Icon button until the  
sounding device emits a long beep, indicating the signal  
has been stored into memory.  
5. If you have additional transmitters (up to 4) that need to  
be programmed, repeat step 4 for each transmitter.  
 

Custom Brackets Car Speaker CSC2264H User Manual
Danby Dehumidifier DDR50A2GP User Manual
Dimension One Spas Hot Tub AquaPro 19 User Manual
Dixon Lawn Mower ZTR 361 User Manual
Escient CD Player SE 160i User Manual
Everpure Water System A 11 User Manual
Fitness Quest Home Gym 2100HR User Manual
Flymo Trimmer 500 XT User Manual
GE Air Conditioner ASW18 User Manual
GE Cordless Telephone GSD6900 60N User Manual